Skeg Guard Megaware Evinrude / Johnson 90-100-115-120-140 2-stroke 1980-2001

Description

This Megaware SkegGuard is
ONLY
for:
Evinrude/Johnson 90 hp, 100 hp, 115 hp, 120 hp, 130 hp, & 140 hp 2 stroke motors from 1980-2001
Model #: 27101
MEGAWARE SKEGGUARD
Inexpensive Solution To a Broken Skeg
The SkegGuard® from Megaware KeelGuard® provides the best of two worlds. It will protect and prevent damage to your motor’s skeg and can also be used to repair and replace an already broken skeg.
Save Hundreds of Dollars on Skeg Repairs and Replacement
The Megaware SkegGuard is constructed of high quality marine grade 316 stainless steel that incorporates an extra reinforced wear tab across the bottom where the skeg is most vulnerable. This 3mm thickened lower plate will withstand damage or abrasion from hidden rocks and debris or accidental ramp dragging. The Megaware SkegGuard conforms to your lower unit to insure there is no discernible drag or compromise in performance. A drain hole keeps water from collecting and remaining stagnant.
Secured with self-locking hardware, the Megaware SkegGuard can be installed with common tools in less than 10 minutes. It will provide years of service and save hundreds of dollars in potential repairs.
If replacing an already broken skeg, the Megaware SkegGuard can be installed on a lower unit with as little as 2 inches of skeg remaining. It will be stronger and much more affordable than welding and replacing a lower skeg.
Mirror polished marine grade 316 stainless steel
Thickened lower wear tab protects against ramp dragging and is great for river running
Drain hole prevents against corrosion and freezing
Won’t compromise performance
Do-it-yourself install in less than 10 minutes
Installs with as little as 2-3 inches of skeg remaining
Three year warranty
Step 1
Using a mallet (leather, rubber or wooden), place the Megaware SkegGuard® on the skeg and gently tap on it to get it started. Once in place, drive it on with the mallet until fully seated.
Step 2
Using the two pre-drilled mounting holes in the Megaware SkegGuard® as pilot holes, drill the skeg using a ¼” drill bit, and install the stainless steel hardware using the hex key tools supplied with the product. (Two sets of hardware with varying lengths provide secure fitment to varying skeg thickness.) The hardware includes a thread locker sealant to prevent loosening of the bolts once installed.